(M)  s i s t e m a   o p e r a c i o n a l   m a g n u x   l i n u x ~/ · documentação · suporte · sobre

  Next Previous Contents

6. Features in the EATA DMA driver

This section describes some of the commands available under Linux to check on the RAID configuration. Again, while references to the eata_dma driver is made, this can be used to check up on any driver.

To see the configuration for your driver, type:

% cat /proc/scsi/eata_dma/N

where N is the host id for the controller. You should see something like this:

EATA (Extended Attachment) driver version: 2.59b
queued commands:         353969
processed interrupts:    353969

scsi0 : HBA PM2144UW
Firmware revision: v07L.Y
Hardware Configuration:
IRQ: 11, level triggered
DMA: BUSMASTER
CPU: MC68020 20MHz
Base IO : 0xef90
Host Bus: PCI
SCSI Bus: WIDE Speed: 10MB/sec.
SCSI channel expansion Module: not present
SmartRAID hardware: present.
    Type: integrated
    Max array groups:              7
    Max drives per RAID 0 array:   7
    Max drives per RAID 3/5 array: 7
Cache Module: present.
    Type: 0
    Bank0: 16MB without ECC
    Bank1: 0MB without ECC
    Bank2: 0MB without ECC
    Bank3: 0MB without ECC
Timer Mod.: present
NVRAM     : present
SmartROM  : enabled
Alarm     : on
Host<->Disk command statistics:
         Reads:      Writes:
    1k:           0            0
    2k:           0            0
    4k:           0            0
    8k:           0            0
   16k:           0            0
   32k:           0            0
   64k:           0            0
  128k:           0            0
  256k:           0            0
  512k:           0            0
 1024k:           0            0
>1024k:           0            0
Sum   :           0            0

To get advanced command statistics, type:

% echo "eata_dma latency" > /proc/scsi/eata_dma/N

Then you can do a:

% cat /proc/scsi/eata_dma/N

to get more detailed statistics.

To turn off advanced command statistics, type:

% echo "eata_dma nolatency" > /proc/scsi/eata_dma/N

Next Previous Contents