|s i s t e m a o p e r a c i o n a l m a g n u x l i n u x||~/ · documentação · suporte · sobre|
Drives larger than 33.8 GB will not work with kernels older than 2.2.14 / 2.3.21. The details are as follows. Suppose you bought a new IBM-DPTA-373420 disk with a capacity of 66835440 sectors (34.2 GB). Pre-2.3.21 kernels will tell you that the size is 769*16*63 = 775152 sectors (0.4 GB), which is a bit disappointing. And giving command line parameters hdc=4160,255,63 doesn't help at all - these are just ignored. What happens? The routine idedisk_setup() retrieves the geometry reported by the disk (which is 16383/16/63) and overwrites what the user specified on the command line, so that the user data is used only for the BIOS geometry. The routine current_capacity() or idedisk_capacity() recomputes the cylinder number as 66835440/(16*63)=66305, but since this is stored in a short, it becomes 769. Since lba_capacity_is_ok() destroyed id->cyls, every following call to it will return false, so that the disk capacity becomes 769*16*63. For several kernels a patch is available. A patch for 2.0.38 can be found at ftp.kernel.org. A patch for 2.2.12 can be found at www.uwsg.indiana.edu (some editing may be required to get rid of the html markup). The 2.2.14 kernels do support these disks. In the 2.3.* kernel series, there is support for these disks since 2.3.21. One can also `solve' the problem in hardware by using a jumper to clip the size to 33.8 GB. In many cases a BIOS upgrade will be required if one wants to boot from the disk.
Next Previous Contents